Edsal 7004 Bedienungsanleitung PDF herunterladen (Seite 2)

This instruction sheet was designed to help you assemble this unit in the proper way, please follow them using all

parts and fasteners provided. Any alteration or deviation from this instruction sheet can result in unit failure. If

you have any assembly problems or questions, please feel free to contact our Edsal manufacturing facility at

(773) 475-3000 during the hours of 9:00 a.m. to 5:00 p.m. central standard time and ask for customer service.

We have people available to assist you if need be with any part of this assembly process.

IT IS HIGHLY RECOMMENDED TO ASSEMBLE THIS UNIT AT EYE LEVEL, AND WITH THE HELP OF AN

ADDITIONAL PERSON. Using a RAISED surface such as a TABLE or DESK, will greatly EASE the ASSEMBLY

PROCESS. Assembly attempted on a much lower surface such as the floor, is still possible but does make the

assembly process longer and harder. During the shipping and handling of this product, some of the panels may

have a MINOR bend such as on a corner, door hinge pin, or a tab. This minor variation can be REPAIRED SIM-

PLY by using a SMALL TOOL or your HAND to move the material back to its designed form. A example will be

outlined in the “GETTING STARTED” section listed below. Some of the materials used in the packaging to pro-

tect the parts from damage may leave dust or smudges on the steel panels. It is RECOMMENDED AFTER AS-

SEMBLY IS COMPLETE to use a MILD SOAP and WATER with a SOFT CLOTH to wipe the unit clean, and

use the SUPPLIED OR SUITABLE FASTENERS to PROPERLY SECURE this unit to a WALL.

Assembly Instructions : Edsal 7004 Quick Assemble Combination Cabinet Page 2

Important Please Read First

The assembly process uses tabs, notches, rectangular, and square holes to hold the parts together. To

speed the assembly process, have a rubber mallet, small blade screwdriver, and a small phillips screwdriver

ready. After unpacking all the panels, visually inspect the corners. These are the most susceptible to dam-

age through the shipping and handling process. If you find a corner bent out of place, use your hand and

gently move the corner back to the designed shape. Also during shipping and handling some of the tabs

used for engaging the panels together may have become closed. Visually inspect all panels and if found that

some are closed, use a small blade screwdriver to push the tabs from behind to open slightly (it is recom-

mend to push tabs out slightly for ease of assembly, and then tap back down with a rubber mallet, to tighten

engagement). A example of pushing the tabs out and how the engagement process works, is shown below.

Getting Started

Piece with tab

goes under piece

with rectangular

hole

Slide part

Tab fully engaged

Step 1 - Back Assembly

Place the left and right hand backs on a level surface.

Position the parts so that all the tabs are facing up.

Place the part with the rectangular holes (left hand back)

over the part with the tabs (right hand back). Making

sure the tabs ride into the rectangular holes, slide the

backs together. Check to make certain that all the tabs

and rectangular holes have engaged completely, then

tap the tabs down for a tight engagement (see figure 1

for references).

Push tab slightly

from back side

to open

Small blade

screwdriver

Figure 1– Back Assembly

Tap tab with rubber

mallet to tighten

engagement

Edsal 7004 Bedienungsanleitung Seite 2

Kommentare zu diesen Handbüchern

Edsal 7004 Bedienungsanleitung Seite 2

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Möbel Edsal 7004