Edsal 7004 Bedienungsanleitung PDF herunterladen (Seite 4)

Assembly Instructions : Edsal 7004 Quick Assemble Combination Cabinet Page 4

Step 5 - Top Shelf & Hanger Rod Assembly

First locate the level just above were the divider will be

installed by selecting the set of square notches located

inside the unit on the left and right back panels. Round

holes are located on the inside of the left and right side

panels near the hinges for the front of the shelf installa-

tion. Using a shelf clip, insert the upper notch into a

round hole opposite the square holes where the shelf is

located. Push and “snap” the lower notch of the clip into

place using the next lowest round hole. Angle the shelf

so that the shelf will engage the square notches on the

back panel and lower onto the front shelf clips. Next

take the hanger rod and fasten it to the top shelf using

the 10-24 x 3/8” screws and nuts (see figure 5 for screw

locations).

Figure 5 - Top Shelf & Hanger Rod Assembly

Figure 6 - Divider Assembly

Figure 7 - Final Assembly

Shelf Clip

Step 6 - Divider Assembly

Holding the divider, notice there are square notches and

round notches on each end of the part. Insert the divider

so that the square notches rest on the back of the cabi-

net, and so that all the flanges are facing toward the right

side of the cabinet or facing away from the hanger rod

(see figure 6 for reference). Align the bolt holes with the

top shelf, and the bottom. After assuring the holes are

aligned, fasten the divider to the top shelf and bottom

using the 10-24 x 3/8” screws and nuts (see figure 6 for

reference and screw locations).

Hanger Bar

Screw Locations

For Hanger

Bar

Top Shelf

Divider

Screw Locations

For Divider to

Bottom

Screw Locations

For Divider to

Top Shelf

Half Shelves

Right Hand

Door

Left Hand

Door

Step 7 - Final Assembly

The doors are ready to be hung. With the hinge pins

pointed down, select the door with three (3) holes for the

handle cutout. This is the right hand door. Take the

right hand door and align the door’s hinge pins with the

companion hinges located on the right side panel. Hinge

pins may have moved or come out of alignment during

shipping. If so, move the pins back to the proper position

so they align with the companion hinge holes. Slide the

pins into the holes to seat the door. Repeat the process

for the left hand door. Installing the half shelves. Re-

fer to step five (5) and follow the instructions of in-

stalling shelves (substituting the divider for the left

hand back & side). To complete the unit, the locking

handle needs to be installed on the right hand door. Fol-

low carefully the assembly instructions in the handle

hardware bag. If wall anchor hardware was supplied

with your model, install the hardware by drilling two

holes into the backs of the cabinet. Drill one on the left,

and one on the right. Then use the toggle bolts THAT

WERE SUPPLIED to secure the cabinet to a wall. If

your unit WAS NOT SUPPLIED with anchor hardware, it

is suggested to use a toggle bolt similar to the picture on

page 1. See your local hardware dealer to purchase this

type of hardware to properly secure the unit to a wall.

1 2 3 4

Kommentare zu diesen Handbüchern

Keine Kommentare

Edsal 7004 Bedienungsanleitung Seite 4

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Möbel Edsal 7004