Edsal 3004 Bedienungsanleitung PDF herunterladen (Seite 4)

Assembly Instructions : Edsal 3004KA & 3005KA Series Combination Cabinets Page 4

Step 5 - Top Shelf & Hanger Bar Assembly

First locate the level just above were the divider will be

installed by selecting the set of square notches located

inside the unit on the left and right back panels. Round

holes are located on the inside of the left and right side

panels near the hinges for the front of the shelf installa-

tion. Using a shelf clip, insert the upper notch into a

round hole opposite the square holes where the shelf is

located. Push and “snap” the lower notch of the clip into

place using the next lowest round hole. Angle the shelf

so that the shelf will engage the square notches on the

back panel and lower onto the front shelf clips. Next

take the hanger bar and fasten it to the top shelf using

the 10-24 x 3/8” screws and nuts (see figure 5 for screw

locations).

Figure 5 - Top Shelf & Hanger Bar Assembly

Figure 6 - Divider Assembly

Step 7 - Final Assembly

Installing the half shelves. Refer to step five (5) and

follow the instructions of installing shelves

(substituting the divider for the left hand back &

side). To complete the unit, the locking handle needs to

be installed on the right hand door. Follow carefully the

assembly instructions in the handle hardware bag. If the

cabinet is not located on a level surface, two (2) leg lev-

elers have been supplied. Install the cage nut over the

holes located in the bottom front of the kick plate, or on

the bottom back return flanges of the sides. Install the

threaded leg leveler into the nut, and adjust as neces-

sary.

Figure 7 - Final Assembly

Shelf Clip

Step 6 - Divider Assembly

Holding the divider, notice there are square notches and

round notches on each end of the part. Insert the divider

so that the square notches rest on the back of the cabi-

net, and so that all the flanges are facing toward the right

side of the cabinet or facing away from the hanger bar

(see figure 6 for reference). Align the bolt holes with the

top shelf, and the bottom. After assuring the holes are

aligned, fasten the divider to the top shelf and bottom

using the 10-24 x 3/8” screws and nuts (see figure 6 for

reference and screw locations).

Hanger Bar

Screw Locations

For Hanger

Bar

Top Shelf

Divider

Screw Locations

For Divider to

Bottom

Screw Loca-

tions

For Divider to

Half Shelves

Right Hand

Door

Left Hand

Door

Rear Leg Leveler

Holes located On

Bottom of Cabinet

at this Point

(opposite side also)

Front Leg Leveler

Holes located

On Bottom of

Cabinet at these

Points

NOTE : DOORS ARE NOT SHOWN IN GRAPHIC

FOR ILLUSTRATION PURPOSES.

NOTE : DOORS ARE NOT SHOWN IN GRAPHIC

FOR ILLUSTRATION PURPOSES.

1 2 3 4

Kommentare zu diesen Handbüchern

Keine Kommentare

Edsal 3004 Bedienungsanleitung Seite 4

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Möbel Edsal 3004